Scheu Products Company SPC-54PHB Spécifications

STOPQUESTIONS?MISSING / DAMAGED PARTSPlease do not return this product to the store.If a part is damaged or missing, simply e-mail usat php@allpro-hea

Page -10-OPERATING INSTRUCTIONSPREPARING FOR OPERATION1.Check the heater for possible shipping damage. If any isfound, immediately notify the factory.

Page -11-SPC-54PHW SPC-54PHB SPC-54PHT-- PARTSItem Part No. Description Qty.1 8603 Valve 1* 8604 Bolt, 1/8-40 23 8605 Tip Switch 14 860

1 8603 Valve 1* 8604 Bolt, 1/8-40 23 8605 Tip Switch 1* 8606 Nut, 1/8-40 25 8607 Fuel Tube 16 8608 Adiabatic Plate 17 8609 Mushroom Burner Ass'y

Page -13-WARRANTYWe are pleased that you have selected our product and takethis opportunity to assure you that qualified service facilities areavailab

WARRANTY REGISTRATIONWarranty RegistrationFirst Name Hand print only. Use black or blue ink pen to fill in this form. Cross or check inside the circle

Visit our website for product information, technical support, customer service, and warranty registration at:WWW.ALLPRO-HEATERS.COM for All-Pro produc

Page -2- GENERAL HAZARD WARNING:FAILURE TO COMPLY WITH THE PRECAUTIONS AND INSTRUCTIONS PROVIDED WITH THIS HEATER, CANRESULT IN DEATH, SERIOUS BODILY

Page -3-OPERATING PRECAUTIONSThis is a propane, direct-fired heater.Propane is heavier than air. If propane leaks from a connectionor fitting, it sink

Page -4-ODOR FADE WARNINGFUEL GAS ODORLP gas and natural gas have man-made odorants added specifically for detection of fuel gas leaks.If a gas leak o

Page -5-ASSEMBLY INSTRUCTIONSFigure 1Components are packed in two cartons. Following islisting of packaged components:BOX 1 OF 2Burner and Control A

Page -6-ASSEMBLY INSTRUCTIONSFigure 3Figure 4Figure 5Step 4Insert Manifold into Pole Support (Figure 5 & 6).Insert the Manifold Assembly through

Page -7-ASSEMBLY INSTRUCTIONSFigure 8Step 5Attach Pole to Pole Support (Figure 7 & 8). PlacePole into the Pole Support center connector. Thentig

Page -8-ASSEMBLY INSTRUCTIONSStep 9 FIRST ASSEMBLY CHECK FOR LEAKSThe heater must be leak tested before any further assembly is done. Use only a soap

Page -9-ASSEMBLY INSTRUCTIONSFigure 13Step 11Attach Dome to Emitter (Figure 13 ).Gently lay Heater Assembly on its side using one ofthe shipping styro